|
This is where I braze and solder. I use acetylene and air for one torch and natural gas and compressed air for two others that give me larger, more intense heat. I use a non-toxic flux (see the air brush with green liquid inside the enclosure to the left) that is hooked up to my air compressor. All fumes are pulled back and up through the blower via articulating elbows (out of sight). A heat-resistant glove hangs to the left of the bench for emergencies. For a close-up of the enclosure interior, go here.
1
• 2 • 3
• 4
• 5
• 6
• 7
• 8
• 9
• 10
• 11
• 12
• 13 • 14
• 15 • 16 |
